[uboot] create uboot from github:

repo: https://github.com/u-boot/u-boot
	commit: d80bb749fab53da72c4a0e09b8c2d2aaa3103c91

Change-Id: Ie6434426e1ec15bc08bb1832798e371f3fd5fb29

u-boot-2021.10/drivers/ddr/marvell/a38x/ddr3_training_ip.h

@@ -0,0 +1,146 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/*
+ * Copyright (C) Marvell International Ltd. and its affiliates
+ */
+
+#ifndef _DDR3_TRAINING_IP_H_
+#define _DDR3_TRAINING_IP_H_
+
+#include "ddr_topology_def.h"
+
+#define TIP_ENG_LOCK	0x02000000
+#define TIP_TX_DLL_RANGE_MAX	64
+
+#define GET_MIN(arg1, arg2)	((arg1) < (arg2)) ? (arg1) : (arg2)
+#define GET_MAX(arg1, arg2)	((arg1) < (arg2)) ? (arg2) : (arg1)
+
+#define INIT_CONTROLLER_MASK_BIT	0x00000001
+#define STATIC_LEVELING_MASK_BIT	0x00000002
+#define SET_LOW_FREQ_MASK_BIT		0x00000004
+#define LOAD_PATTERN_MASK_BIT		0x00000008
+#define SET_MEDIUM_FREQ_MASK_BIT	0x00000010
+#define WRITE_LEVELING_MASK_BIT		0x00000020
+#define LOAD_PATTERN_2_MASK_BIT		0x00000040
+#define READ_LEVELING_MASK_BIT		0x00000080
+#define SW_READ_LEVELING_MASK_BIT	0x00000100
+#define WRITE_LEVELING_SUPP_MASK_BIT	0x00000200
+#define PBS_RX_MASK_BIT			0x00000400
+#define PBS_TX_MASK_BIT			0x00000800
+#define SET_TARGET_FREQ_MASK_BIT	0x00001000
+#define ADJUST_DQS_MASK_BIT		0x00002000
+#define WRITE_LEVELING_TF_MASK_BIT	0x00004000
+#define LOAD_PATTERN_HIGH_MASK_BIT	0x00008000
+#define READ_LEVELING_TF_MASK_BIT	0x00010000
+#define WRITE_LEVELING_SUPP_TF_MASK_BIT	0x00020000
+#define DM_PBS_TX_MASK_BIT		0x00040000
+#define RL_DQS_BURST_MASK_BIT		0x00080000
+#define CENTRALIZATION_RX_MASK_BIT	0x00100000
+#define CENTRALIZATION_TX_MASK_BIT	0x00200000
+#define TX_EMPHASIS_MASK_BIT		0x00400000
+#define PER_BIT_READ_LEVELING_TF_MASK_BIT	0x00800000
+#define VREF_CALIBRATION_MASK_BIT	0x01000000
+#define WRITE_LEVELING_LF_MASK_BIT	0x02000000
+
+/* DDR4 Specific Training Mask bits */
+
+enum hws_result {
+	TEST_FAILED = 0,
+	TEST_SUCCESS = 1,
+	NO_TEST_DONE = 2
+};
+
+enum hws_training_result {
+	RESULT_PER_BIT,
+	RESULT_PER_BYTE
+};
+
+enum auto_tune_stage {
+	INIT_CONTROLLER,
+	STATIC_LEVELING,
+	SET_LOW_FREQ,
+	LOAD_PATTERN,
+	SET_MEDIUM_FREQ,
+	WRITE_LEVELING,
+	LOAD_PATTERN_2,
+	READ_LEVELING,
+	WRITE_LEVELING_SUPP,
+	PBS_RX,
+	PBS_TX,
+	SET_TARGET_FREQ,
+	ADJUST_DQS,
+	WRITE_LEVELING_TF,
+	READ_LEVELING_TF,
+	WRITE_LEVELING_SUPP_TF,
+	DM_PBS_TX,
+	VREF_CALIBRATION,
+	CENTRALIZATION_RX,
+	CENTRALIZATION_TX,
+	TX_EMPHASIS,
+	LOAD_PATTERN_HIGH,
+	PER_BIT_READ_LEVELING_TF,
+	WRITE_LEVELING_LF,
+	MAX_STAGE_LIMIT
+};
+
+enum hws_access_type {
+	ACCESS_TYPE_UNICAST = 0,
+	ACCESS_TYPE_MULTICAST = 1
+};
+
+enum hws_algo_type {
+	ALGO_TYPE_DYNAMIC,
+	ALGO_TYPE_STATIC
+};
+
+struct init_cntr_param {
+	int is_ctrl64_bit;
+	int do_mrs_phy;
+	int init_phy;
+	int msys_init;
+};
+
+struct pattern_info {
+	u8 num_of_phases_tx;
+	u8 tx_burst_size;
+	u8 delay_between_bursts;
+	u8 num_of_phases_rx;
+	u32 start_addr;
+	u8 pattern_len;
+};
+
+struct cs_element {
+	u8 cs_num;
+	u8 num_of_cs;
+};
+
+struct hws_tip_freq_config_info {
+	u8 is_supported;
+	u8 bw_per_freq;
+	u8 rate_per_freq;
+};
+
+struct hws_cs_config_info {
+	u32 cs_reg_value;
+	u32 cs_cbe_value;
+};
+
+struct dfx_access {
+	u8 pipe;
+	u8 client;
+};
+
+struct hws_xsb_info {
+	struct dfx_access *dfx_table;
+};
+
+int ddr3_tip_register_dq_table(u32 dev_num, u32 *table);
+int hws_ddr3_tip_select_ddr_controller(u32 dev_num, int enable);
+int hws_ddr3_tip_init_controller(u32 dev_num,
+				 struct init_cntr_param *init_cntr_prm);
+int hws_ddr3_tip_load_topology_map(u32 dev_num,
+				   struct mv_ddr_topology_map *topology);
+int hws_ddr3_tip_run_alg(u32 dev_num, enum hws_algo_type algo_type);
+int ddr3_tip_is_pup_lock(u32 *pup_buf, enum hws_training_result read_mode);
+u8 ddr3_tip_get_buf_min(u8 *buf_ptr);
+u8 ddr3_tip_get_buf_max(u8 *buf_ptr);
+#endif /* _DDR3_TRAINING_IP_H_ */