Testing if the ccid being instantiated has these methods in
ccid_init().
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Simplifying the code a bit as we're always using DCCP_MAX_ACKVEC_LEN.
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
By using a sequence number for every logged netfilter event, we can
determine from userspace whether logging information was lots somewhere
downstream.
The user has a choice of either having per-instance local sequence
counters, or using a global sequence counter, or both.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Try to allocate the struct file and an unused file
descriptor before we try to pull a newly accepted
socket out of the protocol layer.
Based upon a patch by Prassana Meda.
Signed-off-by: David S. Miller <davem@davemloft.net>
this patch adds support to the VLAN driver to translate IF_OPER_DORMANT of the
underlying device to netif_dormant_on(). Beside clean state forwarding, this
allows running independant userspace supplicants on both the real device and
the stacked VLAN. It depends on my RFC2863 patch.
Signed-off-by: Stefan Rompf <stefan@loplof.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
this patch adds a dormant flag to network devices, RFC2863 operstate derived
from these flags and possibility for userspace interaction. It allows drivers
to signal that a device is unusable for user traffic without disabling
queueing (and therefore the possibility for protocol establishment traffic to
flow) and a userspace supplicant (WPA, 802.1X) to mark a device unusable
without changes to the driver.
It is the result of our long discussion. However I must admit that it
represents what Jamal and I agreed on with compromises towards Krzysztof, but
Thomas and Krzysztof still disagree with some parts. Anyway I think it should
be applied.
Signed-off-by: Stefan Rompf <stefan@loplof.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
It is possible to get redirects from nexthop of "more-specific"
routes.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Check RTF_ADDRCONF|RTF_DEFAULT in rt6_get_dflt_router().
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
This controls whether we accept Prefix Information in RAs.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
This controls whether we accept default router information
in RAs.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
RFC 3041 describes an algorithm to generate random interface
identifier. In RFC 3041bis, it is allowed to use different
algorithm than one described in RFC 3041.
So, let's use our standard pseudo random algorithm to simplify
our implementation.
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Since addrconf_add_dev() has already called addrconf_add_mroute()
to added route for multicast prefix, there's no point to call it
again in addrconf_ip6_tnl_config().
Signed-off-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Currently this will not happen if we exit before rpc_new_task() was called.
Also fix up rpc_run_task() to do the same (for consistency).
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Hi,
When a network interface goes into promiscuous mode, its an important security
issue. The attached patch is intended to capture that action and send an
event to the audit system.
The patch carves out a new block of numbers for kernel detected anomalies.
These are events that may indicate suspicious activity. Other examples of
potential kernel anomalies would be: exceeding disk quota, rlimit violations,
changes to syscall entry table.
Signed-off-by: Steve Grubb <sgrubb@redhat.com>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
We need to ensure that all writes to the XDR buffers are done before
req->rq_received is visible to other processors.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Introduced by NFS metrics patch.
Test plan:
Compile kernel with CONFIG_NFS enabled on a 64-bit platform.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
RPC_DEBUG_DATA no longer needed in net/sunrpc/xprt.c.
Test plan:
Compile kernel with CONFIG_NFS enabled.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Clean-up: replace rpc_call() helper with direct call to rpc_call_sync.
This makes NFSv2 and NFSv3 synchronous calls more computationally
efficient, and reduces stack consumption in functions that used to
invoke rpc_call more than once.
Test plan:
Compile kernel with CONFIG_NFS enabled. Connectathon on NFS version 2,
version 3, and version 4 mount points.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Add fields to the rpc_procinfo struct that allow the display of a
human-readable name for each procedure in the rpc_iostats output.
Also fix it so that the NFSv4 stats are broken up correctly by
sub-procedure number. NFSv4 uses only two real RPC procedures:
NULL, and COMPOUND.
Test plan:
Mount with NFSv2, NFSv3, and NFSv4, and do "cat /proc/self/mountstats".
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Add a simple mechanism for collecting stats in the RPC client. Stats are
tabulated during xprt_release. Note that per_cpu shenanigans are not
required here because the RPC client already serializes on the transport
write lock.
Test plan:
Compile kernel with CONFIG_NFS enabled. Basic performance regression
testing with high-speed networking and high performance server.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Account for various things that occur while an RPC task is executed.
Separate timers for RPC round trip and RPC execution time show how
long RPC requests wait in queue before being sent. Eventually these
will be accumulated at xprt_release time in one place where they can
be viewed from userland.
Test plan:
Compile kernel with CONFIG_NFS enabled.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
Monitor generic transport events. Add a transport switch callout to
format transport counters for export to user-land.
Test plan:
Compile kernel with CONFIG_NFS enabled.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
RPC wait queue length will eventually be exported to userland via the RPC
iostats interface.
Test plan:
Compile kernel with CONFIG_NFS enabled.
Signed-off-by: Chuck Lever <cel@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
