/*!
\file readme.txt
\brief description of the TIMER0_pwmout_complementary signals demo for gd32w51x
\version 2021-10-30, V1.0.0, firmware for GD32W51x
*/
/*
Copyright (c) 2021, GigaDevice Semiconductor Inc.
Redistribution and use in source and binary forms, with or without modification,
are permitted provided that the following conditions are met:
1. Redistributions of source code must retain the above copyright notice, this
list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice,
this list of conditions and the following disclaimer in the documentation
and/or other materials provided with the distribution.
3. Neither the name of the copyright holder nor the names of its contributors
may be used to endorse or promote products derived from this software without
specific prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT,
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
OF SUCH DAMAGE.
*/
This demo is based on the GD32W515P-EVAL-V1.0 board, it shows how to
configure the TIMER0 peripheral to generate three complementary TIMER0 signals.
TIMER0CLK is fixed to systemcoreclock, the TIMER0 prescaler is equal to 9000
so the TIMER0 counter clock used is 20KHz.
The Three duty cycles are computed as the following description:
The channel 0 duty cycle is set to 25% so channel 0N is set to 75%.
The channel 1 duty cycle is set to 50% so channel 1N is set to 50%.
The channel 2 duty cycle is set to 75% so channel 2N is set to 25%.
Connect the TIMER0 pins to an oscilloscope to monitor the different waveforms:
- TIMER0_CH0 pin (PA8)
- TIMER0_CH0N pin (PB13)
- TIMER0_CH1 pin (PA9)
- TIMER0_CH1N pin (PB14)
- TIMER0_CH2 pin (PA10)
- TIMER0_CH2N pin (PB15)
