/*!
\file readme.txt
\brief description of the TIMER1 PWM output demo for gd32w51x
\version 2021-10-30, V1.0.0, firmware for GD32W51x
*/
/*
Copyright (c) 2021, GigaDevice Semiconductor Inc.
Redistribution and use in source and binary forms, with or without modification,
are permitted provided that the following conditions are met:
1. Redistributions of source code must retain the above copyright notice, this
list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice,
this list of conditions and the following disclaimer in the documentation
and/or other materials provided with the distribution.
3. Neither the name of the copyright holder nor the names of its contributors
may be used to endorse or promote products derived from this software without
specific prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT,
INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
OF SUCH DAMAGE.
*/
This demo is based on the GD32W515P-EVAL-V1.0 board, it shows how to configure the
TIMER peripheral in PWM (Pulse Width Modulation) mode.
The TIMxCLK frequency is set to systemcoreclock, the prescaler is 180 so the
TIMER1 counter clock is 1MHz.
TIMER1 Channel0 duty cycle = (4000/ 16000)* 100 = 25%.
TIMER1 Channel1 duty cycle = (8000/ 16000)* 100 = 50%.
TIMER1 Channel2 duty cycle = (12000/ 16000)* 100 = 75%.
@note
Connect the TIMER1 pins to an oscilloscope to monitor the different waveforms:
- TIMER1_CH1 pin (PA0)
- TIMER1_CH2 pin (PA1)
- TIMER1_CH3 pin (PA2)
